I doubt it as thta would make it difficult to hook up since the mb would already be mounted. The x = no pin on the header.Thanks a lot for looking at my question.Edited by TropicalBob, 23 October 2013 - 02:22 PM. What I need is the headers in the first image, I've drawn them on the image, below the board and numbered tham with my own numbers. Some of the numbers let me to Foxconn too but I could not tell it it was the same.If these header pins are standardized I can read the markings off another board, I just did not want to fry a working board since replacement money is not available even for an old system like this one. The only thing I have found is that it possibly a Foxconn mb.There is no 'make' other than emachines but on the rear of the original case two stickers have: Model W3644The CPU is an AMD Sempron.I had hoped that I had shown the MB manufacturer in the images, guess I missed it. Can you give me the make and model number of the emachines system?The mb numbers you supplied are not giving any results on a search. Just knowing what to plug where would be great, I could not find a matching manual online.Thanks very much.TropicalBob. These numbers are on the board:WinfastN15235WYSV80404553 PCMCP615M2MA-RS2H(this located by the RAM sockets)020205Y00-006-GPhoto attached should show the pins on the board as well as the numbers. These are not labeled that I can see on the board.Tech:Everything worked great before I unplugged it. I made a beginner's mistake and did not note where the power switch, reset, HDD-LED and such plug into the board. Hi, I moved a working Winfast motherboard (from an emachine) to a new case to take advantage of a larger power supply and cooler space.

Driver foxconn winfast n15235 manual